 |
Set up.
(1)Click "WAN Setup". (2)Select "PPP USB". (3)At "Connection Method", select "Specified Connection".
*"Standard Connection" is selectable, but it is not supported. (4)Enter the following:
| Telephone Number |
Enter the accesspoint "Phone number". |
| USER ID |
Enter the Login ID given by the provider. |
| Password |
Enter the password given by the provider. |
| Confirm Password |
Enter the same password again for confirming. |
Set up the following items if needed.
| DNS Selection |
If the secondary DNS address is specified from the provider, click "Setup" and enter "Primary DNS" or "Secondary DNS" if the Secondary DNS is provided.
The default setting is "Auto". |
| MTU |
Set up MTU figure. Usually, use as "1454". |
| Dial-On-Demand |
The connection is performed automatically when communication occurs. Default setting is Off. |
| Silent Timeout |
When there is no communication during the numbers of seconds which is set up, it is cut automatically. |
| Auto Recconect |
When the cut from a server occured, the connection is performed automatically again. Default setting is On. |
(5)Click [Apply].
▼
Display the message and the countdown starts.
|
