 |
Disconnect the LAN cable from the LAN port of this product and the PC.
|
 |
Disconnect the power connector from this product.
|
 |
Shift the changeover switch on the rear side of this product to the "AP" side (access point mode).
|
 |
(1)Connect this product to the router with built-in modem or the broadband router by the LAN cable.
*Connects to any of LAN1 to LAN4 ports. The WAN port cannot be used.
(2)Connect attached AC adaptor to the power connector of this product.
|
 |
Power on in the following order:
(1) The router with built-in modem or the broadband router
(2) This product
|
 |
Confirm the lighting (blinking) of LED.
*LED corresponding to the port where the cable is connected lights or blinks.
|
If LED does not light up (blink):
-Please check if the power cable and the LAN cable are inserted firmly.
-Confirm the kind of LAN cable. |
This completes the wireless access point mode setup. |
